# Ollama

Source: https://everywhere.sylinko.com/en/docs/model-provider/ollama

This tutorial will guide you step-by-step on how to connect to a local model from [Ollama](https://ollama.com).

**Notice**

* Using Ollama with Everywhere is an advanced feature. It is recommended to configure and use it only after understanding how it works. Compatibility is not guaranteed.
* Please use **Advanced Mode** for manual setup.

## Prerequisites

* Considering that local models are running, it is recommended to use a computer with good performance.

## Steps

* Download and install the Ollama application from the [Ollama official website](https://ollama.com/download).

![Download Ollama](https://everywhere.sylinko.com/model-provider/ollama/download.webp)

* After installation, open the Ollama application and wait for it to initialize. Then, open a command-line tool (such as PowerShell or CMD) and enter the following command to verify if the Ollama CLI is available:

```bash
ollama -v
```

* If the command line outputs the version number of Ollama, the installation is successful. Otherwise, please refer to the [Ollama official documentation](https://docs.ollama.com). Next, you can choose and download a local model. Search for models supported by Ollama [here](https://ollama.com/search). For example, to download the `gemma3:12b` model:

```bash
ollama pull gemma3:12b
```

* After the download is complete, enter `ollama list` in the terminal to ensure that the downloaded model is in the results.
* In Everywhere's Custom Assistant, switch to **Advanced Mode**:
  * Set **URL** to `http://127.0.0.1:11434` (Ollama's default address)
  * Set **Model ID** to `gemma3:12b` (or the name of another model you downloaded).

![Configure Ollama](https://everywhere.sylinko.com/model-provider/ollama/configuration-en.webp)

* Once the setup is complete, you can start using it.

## FAQ

### Chat message displays `ModelDoesNotSupportTools`

If you encounter a chat message displaying `ModelDoesNotSupportTools` when using an Ollama model, it usually means that the Ollama model you are using does not support the tool-calling feature. You can try switching to another model that supports tool calling, or disable the tool-calling feature in Everywhere to avoid this error.
